Description
Battery Holder - 4xAA to Barrel Jack Connector
This is a simple 4 cell AA battery holder. The 5-inch cable is terminated with a standard 5.5x2.1mm, center-positive barrel jack connector.
The Barrel Jack connector mates with the barrel socket on the Arduino (among a number of other products) allowing you to easily make your project battery powered.
Notes:
- The average voltage regulator has about 1V of dropout (but can vary greatly). This pack, with normal alkaline batteries, will output ~5.5V causing a normal 5V board to run at around 4 to 4.5V. This depends a lot on the board and processor you are using with the battery pack. Always consult your datasheet if in doubt.
1 Review
-
Title of review 962
From start to delivery everything was quick and efficant.
Related Products
Battery Holder - 4xAA Square
Sparkfun
£2.50
Battery Holder - 4xAA Square
Simple 4 Cell AA Battery holder with 5" tinned leads, square configuration.
Battery Holder 4xAA with Cover and Switch
Sparkfun
£2.10
Battery Holder 4xAA with Cover and SwitchThis 4xAA battery holder puts a nice finishing touch on your battery-powered project.This AA holder features a removable, sliding cover, which is secured with...
4 X AA Battery holder with on/off switch and 2.1mm Barrel jack
Proto-PIC
£3.40
4 X AA Battery holder with on/off switch and 2.1mm Barrel jack
This is a simple 4 cell AA battery holder. The 20CM (Approx) cable is terminated with a standard 5.5x2.1mm, center positive barrel jack...
DC Barrel Power Jack / Connector
Sparkfun
£0.60
DC Barrel Power Jack / Connector
A DC power jack/connector. This is a common barrel-type power jack for DC wall supplies.These are compatible with our DC mains supplies and have a 5mm jack, with a 2...
9V Battery Holder with DC Male Jack, 2.1x5.5mm
Sparkfun
£3.30
9V Battery Holder with DC Male Jack, 2.1x5.5mmThis 9V battery holder allows your battery to snap in tight and holds it in place, which is great in situations where you don’t want the battery just...