Description
Jumper - 2 Pin
These are two pin jumpers (also called shunts) that will create an electrical connection between two pin headers.
These are commonly used to modify settings on a board or device.
Do you remember when you had to set an IDE hard drive as ‘Master’ or ‘Slave’ on the IDE ribbon? These jumpers are priceless if you sneeze and lose one.
Related Products
Jumper Wire - JST to Female Connector - 2-pin
Sparkfun
£1.45
Jumper Wire - JST to Female Connector - 2-pin
This is a simple two wire cable.One end has a 2 pin female 0.1" pitch connector. The opposite end has a 2-pin JST connector.The wires are twisted...
Automotive Jumper 2-Pin Wire and Connector Assembly
Sparkfun
£2.50
Automotive Jumper 2-Pin Wire and Connector Assembly
This is a simple two wire cable. It has bare wires on both ends with a Molex A and B connector in the middle.We've also used thicker 18 AWG wire,...
Jumper Wire - 2-Pin to PTH (Black, White)
Sparkfun
£0.80
Jumper Wire - 2-Pin to PTH (Black, White)
This is a simple two wire cable.One end has a 2-pin 0.1" pitch female connector, the opposite end is stripped and tinned stranded wire.
Dimensions:
120mm (4...
Molex Jumper 2-Pin Wire and Connector Assembly
Sparkfun
£1.00
Molex Jumper 2-Pin Wire and Connector Assembly
This is a simple two wire cable. Great for jumping from board to board or just about anything else.There is a 2-pin Molex connector with 0.1" spacing on...
Jumper Wire - 0.1" (2.54mm), 2-pin, 6" (150mm)
Sparkfun
£1.45
Jumper Wire - 0.1" (2.54mm), 2-pin, 6" (150mm)
This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin JST RE connector on both ends...